Used to connect multiple valves in irrigation systems
LASCO’s telescopic manifold system accomodates replacing valves (with different lay lenghts) and without cutting or adding new parts
Male valve connectors connect directly to female valves without the need for manifold nipples
Bigger O-Rings for leak free connection
Parts are all hand tightened (except for glued connections)
No teflon tape needed for assembly
Pressure rated at 150 psi or 1034 kpa
|Lasco 2 Outlet Manifold 25mm||Lasco 3 Outlet Manifold 25mm||Lasco 4 Outlet Manifold 25mm|
|Type||Multi-Port Manifold Fitting||Multi-Port Manifold Fitting||Multi-Port Manifold Fitting|
|Inlet Thread Size||25mm BSPM, 25mm BSPF||25mm BSPM, 25mm BSPF||25mm BSPM, 25mm BSPF|
|Outlet Thread Size||25mm BSPM||25mm BSPM||25mm BSPM|
|Max. Recommended Pressure (kPa)||1034||1034||1034|
Are there any safety standards my irrigation system must meet?
The main safety concern is regarding the water supply. To avoid contamination of the mains water upstream, in most municipalities, a Dual Check Valve is required at the water connection.
Can I run an irrigation system off a regular garden tap?
A garden tap is an excellent place to connect your irrigation system. Ideally, install a connection point behind the tap (turn the water off first) so you can still use your tap to fill a bucket when you need to.
Do I need a plumber to install or fix my system?
No, unless you’re tapping into your water supply, a plumber isn’t required. Most domestic irrigation systems can be installed by anyone half handy.
Do I need to use teflon tape? How much do I need to use?
Whenever you’re connecting two threaded fittings, teflon is required. The only exception is whenever either fitting has an O-ring, in this case, do not apply teflon as it may cause the O-ring to not seal correctly. The amount of teflon you apply depends on the application. In any constant pressure applications you look at up to wrapping around the thread up to 20 times, whereas in any non-constant pressure applications, like on irrigation risers, 2 or 3 times around the thread is enough.
I want to design & install an irrigation system. Where do I start?
Well you’re in the right place! We’ve got it all here. The first step, is drawing out a plan of your garden, to scale of course. If you need help on how to do that, you can get started right here!
Why should I buy from an Australian website?
We get any number of calls from people across the country who've bought from overseas & have problems. From electrical output problems to thread compatibility problems & other problems that we aren't able to help with!
By buying from SunshowerOnline, right here in Australia, you can be sure that your warranty issues are covered, that compatibility & compliance isn't an issue & that you'll be able to get helpful after service advice.